Restringing the weed eater is the same for all of the bump heads except for minor differences in the amount of line required for the spools and the alignment. With the trimmer turned off twist the inner spool counterclockwise to align its arrows with the arrows the outer spool.
The spool is made up of two components an outer spool and an inner reel.
How to restring a troy bilt weedeater. Bend over the short end of each line and insert it into the adjacent anchor hole. Push one end of the line through the eyelet on the side of the outer spool and pass it through the line loading hole on the. Learn how to install new string trimmer line in a traditional bump head.
Cut a piece of replacement line 10 feet long. Line up the arrows feed in the line see how. Pull them through so that the ends match up and two to three inches of trimmer line remain.
Shut off the weed eater and. With the tension released remove any leftover line by pulling on it. Insert the short ends of the trimmer line into the other inner reel hole and then pull the long end of the string to close the loop.
Turn the bump knob clockwise until the arrows are aligned. Remove old trimming line and any other obstructions from the trimmer head. Turn the inner spool clockwise to wind the string on the speed spool until approximately 4 inches of line remains on the outside of.
Hold the outer spool with one hand to prevent it from turning. With the trimmer turned off twist the inner spool counterclockwise to align its arrows with the arrows the outer spool. Push one end of the line through the eyelet on the side of the outer spool.
Easy to re string TroyBilt TB425CS trimmer and without winding it on the reel as some are trying to do first. Cut a section of trimming line that is approximately 20 feet 6 meters in length. Place the new trimming.
Restring A Troy-bilt Weed Eater. In this video I go over two ways to replace the string in a troy-bilt weed eater. In this video I go over two ways to replace the string in a troy-bilt weed eater.
Out of the box setup mixing oil and fuel boom installation starting procedures operation line replacement and servicing of the Troy-Bilt TB22 EC String Trimmer How-To Articles at Troy-Bilt. Troy-Bilt trimmers use a line spool mechanism known as a SpeedSpool to make replacing a broken line quick and hassle-free. Hold the outer spool in.
Feed a 10-foot length of string through each of the two holes in the top of the spool and pull them through until about 3 inches are left. How To Restring A 22 String Trimmer How To Put Trimmer Line On A Troy Bilt Weed Eater How To Replace String On Troy Bilt 2cyle Trimmer Troy-bilt Gas Trimmer Tb590 Replace Broken Starter Rope How To Restring A Troy Bilt Tb525 Ec Weed Eater How To Restring A Weedeater. Guys Ive done this several times and have it down to a quick science now so I made this video to share all the shortcuts Ive learned with you so that you.
Then wind both strings around the spool in the direction of the arrow until about 6. The Troy-Bilt owners manual specifies using only 0080-inch trimming line. 1 Flip the switch to the Off position and unplug the electrical cord from the outlet.
This video shows how to use a trimmer head. Locate the two holes on the top of the inner real and insert one end of each length of trimmer line into one of the holes.